Komatsu Arm Cylinder Seal Kit 707-99-76180 707-99-76180 Fits PC500LC-8R PC500LC-8 Arm Cylinder Repair Kit

Komatsu Arm Cylinder Seal Kit 707-99-76180 707-99-76180 Fits PC500LC-8R PC500LC-8 Arm Cylinder Repair Kit

Product Show:

Related Part:

Storage conditions for seals:

1. The storage room temperature of the seals should preferably be below 30 °C to avoid high temperature aging of the seals;

2. The seal must be stored in a sealed package to avoid contact with moisture or dust in the air;

3. The seals must be protected from strong light to avoid the seals being eroded by ozone in the air or prematurely aging.

The factors affecting the performance of various seals are different, such as mechanical seals (packing seals, etc.) affecting factors such as temperature, medium, wear, and pressure.

We also have the following products available:

Hydraulic Oil Seals

Hydraulic Breaker Seal Kit

Transmission Seal Kit

Center Joint Seal Kit

Track Adjuste Seal Kit

Control Valve Seal Kit

Hydraulic Pump Seal Kit

Gear Pump Seal Kit

Pilot Valve Seal Kit

Swing Motor Seal Kit

Travel Motor Seal Kit

Precautions:

1. Before designing grooves, please read the descriptions of each series of products by yourself, and clearly distinguish whether the product uses an integral groove or a split groove; during the process of installing the seals, pay attention to avoid sharp edges, and the hole seals must be installed in the integral groove. With the help of installation tools; the designer must consider parameters such as groove dimensional accuracy, surface roughness, extrusion gap, etc. For details, please refer to the product instruction manual, diagram and size table.

2. Before installing the seal, it must be ensured that there are no impurities and cracks in the sealing groove, and operating oil should be applied to the sealing groove and the surface of the seal respectively; the seals should be installed gradually in sequence; Avoid twisting and skewing; if it is a split slot, tighten the gland last.